Taramps 6-FH 300S 6-Inch 4-Ohm Speakers, 150W RMS Each, Pair

Build your speaker project around a matched model pair: two Taramps 6-FH 300S 6-inch drivers in black. Designed for a broad listed frequency range, these drivers emphasize reproduction from midbass through the higher frequencies for compatible sound systems.

Key Features

• Pair includes two Taramps 6-FH 300S speaker drivers.
• Listed power handling of 150W RMS per driver, or 300W RMS combined across the pair.
• Nominal impedance of 4 ohms per driver.
• Listed frequency response from 90Hz to 18kHz.
• Phase plug and cellulose horn described in the supplied product information.
• Steel basket and CCAW voice-coil wire.

Core Specifications

• Brand: Taramps
• Model: 6-FH 300S
• Quantity: Two drivers
• Nominal diameter: 6 inches each
• Color: Black
• Power handling: 150W RMS each
• Nominal impedance: 4 ohms each
• Sensitivity: Listed as 93.015dB at 1W/1m, free-air.
• Frequency response: 90Hz–18,000Hz; tolerance unspecified.
• Voice-coil diameter: 1.5 inches
• Voice-coil height: 10.5mm
• Voice-coil wire: Round-section CCAW
• Voice-coil former: Kapton, according to the source.
• Basket: Steel
• Magnet material: Barium ferrite

Listed Driver Parameters

• Resonant frequency (Fs): 105.393Hz
• Qms: 3.791; Qes: 0.657; Qts: 0.560
• Equivalent compliance volume (Vas): 7.305L
• Moving mass (Mms): 9.355g; diaphragm mass (Mmd): 8.348g
• Force factor (BL): 5.317Tm
• Voice-coil inductance at 10kHz: 0.2008mH
• Effective cone area (Sd): 0.0145 square meters
• Listed Xmax: ±3.7mm
• Gap flux density: 10,700 gauss
• Magnet dimensions: 115 x 56 x 18mm
• Gap height: 6.35mm
• Listed driver displacement within an enclosure: 0.60L

Parameters are taken from the supplied listing, not independent measurements. The source lists two DC-resistance values, 3.0 and 5.6 ohms, without identifying the applicable version. Confirm the correct 4-ohm model datasheet before designing an enclosure. Vas and driver displacement are not recommended enclosure volumes.

Power, Wiring and Fit

The combined 300W RMS figure represents the sum of two 150W RMS ratings, not 300W per speaker. Each driver remains nominally 4 ohms; final amplifier load depends on the wiring arrangement. Have a qualified installer verify amplifier compatibility, enclosure design, filtering, polarity and operating levels.

The nominal 6-inch size does not establish the mounting cutout, bolt pattern or depth. Confirm actual fitting dimensions before modifying an enclosure. A broad frequency-response listing does not guarantee deep-subwoofer performance or compatibility with every system.

Contents and Care

Includes two Taramps 6-FH 300S drivers. Enclosures, amplifiers, cables, crossover networks and mounting accessories are not specified as included.

• Disconnect the amplifier before installation or wiring.
• Avoid clipping and excessive low-frequency excursion; follow the manufacturer's recommended operating limits.
• Keep dry and protect cones and terminals from impact or damage.
• Use hearing-safe listening levels.

The specification section states a weight of 1.96kg without explicitly confirming whether it applies per driver or per pair. Confirm this before shipping calculations; no packed shipping weight is claimed.