Taramps THS 6000 4-Channel Receiver Amplifier, 400W RMS

Bring music to your shop, leisure space or home audio setup with the Taramps THS 6000. This four-channel receiver combines multiple playback sources, flexible speaker configurations and onboard tone controls in one unit.

Key Features

• Listed total output of 400W RMS: four channels rated 100W RMS each at 2 ohms.
• Supports four-, three- or two-channel configurations when wired according to the manufacturer instructions.
• Bluetooth, USB, memory-card, AUX and optical audio inputs.
• Unamplified Line Out for compatible external equipment, such as an active subwoofer.
• Three-band equalization and fixed-frequency high-pass and low-pass filtering.
• FM radio with a listed 87.5–108MHz tuning range.

Power and Audio Specifications

• Model: Taramps THS 6000
• Listed output: 4 x 100W RMS at 2 ohms; 200W RMS at 4 ohms per bridged output.
• Nominal load: 2 ohms per channel or 4 ohms bridged. Follow the manual for wiring and permitted configurations.
• Output voltage: 14.2V RMS per channel; 28.4V RMS bridged.
• THD + N: Less than 3% at 100W, according to the supplied specifications.
• Frequency response: 15Hz–20kHz (-3dB).
• Signal-to-noise ratio: Greater than 70dB.
• HPF and LPF: Fixed 100Hz, listed slope 12dB/octave; confirm filter routing in the manual.
• Equalizer: Low ±12dB at 80Hz; mid ±12dB at 2kHz; high ±12dB at 10kHz.
• Listed protections: Short circuit, low impedance and overheating.

AC Supply and Installation

• Listed AC input ranges: 90–140V or 190–240V. These are separate ranges, not a continuous 90–240V specification.
• Maximum listed power consumption: 508W; standby consumption: 3.5W.
• Listed internal protection fuse: 6A. Internal service must be performed by qualified personnel.

Have a qualified installer confirm mains compatibility, any required voltage-selection procedure, speaker loads, wiring and ventilation before use. Audio output ratings are not mains consumption ratings. Speaker compatibility depends on electrical requirements, not simply whether a speaker is marketed for home or automotive audio.

Included in the Package

• 1 THS 6000 receiver
• 1 remote control
• 1 optical cable
• QR code for downloading the manual
• 1 Taramps sticker

Package contents are based on the supplied listing; verify the current package before purchase. Speakers and other external equipment are not listed as included.

Equipment Measurements and Care

Listed equipment dimensions (W x H x D): 39.8 x 5.9 x 19.4cm. Listed equipment weight: 2.20kg. These are not measured packed shipping dimensions or weight.

Keep dry, provide ventilation and disconnect from mains before external wiring or cleaning. Do not open the enclosure. Avoid clipping, incompatible speaker loads and unsafe listening levels. Follow the current manufacturer manual for installation, operation and service. Protection features do not guarantee prevention of damage.