Banda Electra Bass 12K 12000W RMS Car Amplifier 1 ohm

High-output amplification for a carefully planned bass system

The Banda Audioparts Electra Bass 12K 1-ohm version is a car audio amplifier with listed output of 12,000W RMS at 1 ohm. Its adjustable subsonic filter, low-pass crossover and variable bass boost give a qualified installer controls for configuring a compatible bass system.

Picture your next listening session after your installer has matched the enclosure, speaker load, electrical supply and gain settings. The Electra Bass 12K provides bass-focused adjustments for a purpose-built installation rather than a simple plug-and-play upgrade.

Key Benefits

• Listed 12,000W RMS output at a 1-ohm speaker load.
• Adjustable subsonic high-pass filter from 22–65Hz.
• Adjustable low-pass crossover from 80–250Hz.
• Variable bass boost centered within 30–80Hz, with up to 12dB adjustment.
• Aluminum chassis, as described in the existing specifications.

Specifications

• Brand: Banda Audioparts
• Model: Electra Bass 12K
• Version: 1 ohm
• Listed RMS output: 12,000W at 1 ohm
• Supply range: 9–15V DC
• Frequency response: 22Hz–1kHz (-3dB)
• Input impedance: 100k ohms
• Input sensitivity: 300mV–8V
• Listed signal-to-noise ratio: 80dB
• Listed THD at full power: less than 1.5%
• Listed efficiency at nominal impedance: 76%
• Subsonic high-pass filter: 22–65Hz
• Low-pass crossover: 80–250Hz
• Bass boost: 30–80Hz, up to 12dB
• Listed standby current: approximately 2.5A
• Listed maximum current draw: 650A with music; 1,200A with a sine signal
• Dimensions (H × W × D): 73 × 256 × 452mm
• Country of origin: Brazil

Ratings are carried over from the existing product specifications. The available listing does not state the power-test voltage. Actual output depends on the electrical supply, speaker load and operating conditions.

Electrical Planning and Professional Installation

The existing specifications list a 600A fuse and a minimum 70mm² power cable. These are planning references, not a complete installation prescription. A qualified specialist must confirm cable length and routing, circuit protection, grounding, battery and charging capacity, ventilation and the manufacturer's requirements for this exact model.

Verify speaker impedance and power handling before connection. Do not operate below the rated 1-ohm minimum load. Set gain, filters and bass boost to suit the connected speakers and enclosure; excessive boost can increase clipping and equipment stress.

Keep the amplifier protected from moisture and provide adequate mounting clearance and airflow. Professional installation is essential for this high-current application.

Choose the Electra Bass 12K 1-ohm version for a compatible bass system backed by carefully engineered electrical support.